Cisco Systems OL-4580-01 manual Showing RIP Configurations, Field, Description

Chapter 5 Configuring Routing Information Protocol

Showing RIP Configurations

Showing RIP Configurations

Use the show rip command to show a RIP configuration for one IP address or all IP addresses configured in the CSS. This command provides the following options and variables:

•show rip - Displays RIP configurations for all interfaces

•show rip ip_address - Displays a single RIP interface entry

•show rip globals - Displays RIP global statistics

•show rip statistics - Displays RIP interface statistics for all interfaces

•show rip statistics ip_address - Displays RIP interface statistics for a specific interface

Table 5-2describes the fields in the show rip command output.

Table 5-2 Field Descriptions for the show rip Command

Field	Description
IP Address	The advertised RIP interface address.
State	The operational state of the RIP interface.
RIP Send	The RIP version that the interface sends. The possible field
	values are as follows:
	• none - Do not send RIP packets
	• RIPv1 - Send RIP version 1 packets only
	• RIPv2 - Send RIP version 2 packets only (default)
RIP Recv	The RIP version that the interface receives. The possible
	values are as follows:
	• both - Receive both version 1 and version 2 (default)
	• none - Receive no RIP packets
	• Ripv1 - Receive RIP version 1 packets only
	• Ripv2 - Receive RIP version 2 packets only
Default Metric	The default metric used for advertising the RIP interface.

	Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01		5-5