Cisco Systems OL-4580-01 manual Configuring ARP Mapping, Config# no arp

Chapter 4 Configuring the Address Resolution Protocol

Configuring ARP Mapping

Configuring ARP Mapping

To define a static ARP mapping, use the arp command. The syntax for this global configuration mode command is:

arp ip_or_host mac_address interface {vlan}

The variables and options are as follows:

•ip_or_host - The IP address of the system for static mapping. Enter an IP address in dotted-decimal notation (for example, 192.168.11.1) or in mnemonic host-name format (for example, myhost.mydomain.com).

•mac_address - The MAC address of the system mapped to the IP address. Enter the MAC address in hyphenated-hexadecimal notation (for example, 00-60-97-d5-26-ab).

•interface - The CSS Ethernet interface port that you want to configure. For a CSS 11501, enter the interface name in interface port format (for example, e2). For a CSS 11503 or CSS 11506, the interface format is slot/port (for example, 3/1).

•vlan - The number of the VLAN configured in a trunked interface on which the ARP address is configured (assuming trunking is enabled for the CSS Gigabit Interface port). Enter an integer from 1 to 4094 as the VLAN number.

For example:

(config)# arp 192.168.11.1 00-60-97-d5-26-ab e2

To remove a static mapping address, use the no arp command. For example:

(config)# no arp 192.168.11.1

Note The CSS discards ARP requests from hosts not on the same network as the CSS circuit IP address. Thus, if a CSS and a host are within the same VLAN but configured for different IP networks, the CSS does not respond to ARP requests from the host.

	Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01		4-3