Cisco Systems OL-4580-01 manual Shutting Down an Interface, Shutting Down All Interfaces

Chapter 1 Configuring Interfaces and Circuits

Configuring Interfaces

Shutting Down an Interface

To shut down an interface, use the admin-shutdownor shut command.

Caution Shutting down an interface terminates all connections to the interface.

For example:

•To shut down interface e3 on the CSS 11501 with the admin-shutdowncommand, enter:

(config-if[e3])# admin-shutdown

•To shut down interface e3 on the CSS 11501 with the shut command, enter:

(config-if[e3])# shut

When you use the shut command, the CSS changes the shut command to the admin-shutdowncommand in the running configuration.

Note If you configure the redundancy-phycommand on an interface and then disable the interface using the admin-shutdowncommand, the master CSS fails over to the backup CSS. To prevent the CSS from failing over when you administratively disable the interface, remove the redundancy-phycommand by entering no redundancy-phybefore you enter the admin-shutdowncommand on that interface.

Shutting Down All Interfaces

To shut down all interfaces simultaneously, use the admin-shutdowncommand. This command is only available in the SuperUser mode. The admin-shutdowncommand provides a quick way to shut down all physical devices in the CSS except the console and Ethernet management ports.

Caution Shutting down an interface terminates all connections to the interface.

	Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01		1-29