Cisco Systems OL-4580-01 manual 12describes the fields in the show rip command output

Chapter 1 Configuring Interfaces and Circuits

Configuring RIP for an IP Interface

Table 1-12describes the fields in the show rip command output.

Table 1-12 Field Descriptions for the show rip Command

Field	Description
IP Address	The advertised RIP interface address.
State	The operational state of the RIP interface.
RIP Send	The RIP version that the interface sends. The possible values
	are as follows:
	• none - Do not send RIP packets
	• RIPv1 - Send RIP version 1 packets only
	• RIPv2 - Send RIP version 2 packets only (default)
RIP Recv	The RIP version that the interface receives. The possible
	values are as follows:
	• both - Receiving both version 1 and version 2 (default)
	• none - Receiving no RIP packets
	• Ripv1 - Receiving RIP version 1 packets only
	• Ripv2 - Receiving RIP version 2 packets only
Default Metric	The default metric used when advertising the RIP interface.
Tx Log	The setting for the logging of RIP packet transmissions
	(Enabled or Disabled). The default setting is disabled.
Rx Log	The setting for the logging of RIP packet received (Enabled
	or Disabled). The default setting is disabled.

To display global RIP statistics, enter:

#show rip globals

	Cisco Content Services Switch Routing and Bridging Configuration Guide
1-42	OL-4580-01