Cisco Systems OL-4580-01 manual Showing IP Interfaces, Field, Description, 1-38

Chapter 1 Configuring Interfaces and Circuits

Configuring Circuits

Showing IP Interfaces

Use the show ip interfaces command to display configured IP interfaces on the CSS. The display includes the circuit state, IP address, broadcast address, Internet Control Message Protocol (ICMP) settings, and Router Discovery Program (RDP) settings. For example:

#show ip interfaces

Table 1-11describes the fields in the show ip interfaces command output.

Table 1-11 Field Descriptions for the show ip interfaces Command

		Field	Description
		Circuit Name	The name of the circuit associated with the IP interface.
		State	The state of the IP interface. The possible states are as
			follows:
			• Active (1) - The interface is up
			• Disabled - The interface is disabled
			• NoCircuit - The interface is waiting for an underlying
			circuit
		IP Address	The IP address assigned to the circuit.
		Network Mask	The network mask of the circuit.
		Broadcast Address	The broadcast IP address associated with the IP interface.
			If left at zero, the all-ones host is used for numbered
			interfaces. 255.255.255.255 is always used for
			unnumbered interfaces.
		Redundancy	Indicates whether the redundancy protocol is running on
			the interface. The default state is Disabled.
		ICMP Redirect	Indicates whether the transmission of Internet Control
			Message Protocol (ICMP) redirect messages is Enabled or
			Disabled. The default state is Enabled.
		ICMP Unreachable	Indicates whether the transmission of ICMP Destination
			Unreachable messages is enabled or disabled. The default
			state is Enabled.
		RIP	Indicates whether RIP is Enabled or Disabled.
	Cisco Content Services Switch Routing and Bridging Configuration Guide
1-38			OL-4580-01