3. Select a water level
l
Setting the washer to fill with less
water also sets it for shorter wash
time (6 minutes).
- Push the Cycle Control Knob in and
turn it clockwise to a FILL area in the
REGULAR HEAVY Cycle.
- Pull the Cycle Control Knob out; the
washer will start to fill.
-When the washer reaches the
desired water level, push in the Cy-
cle Control Knob and slowly turn un-
til it points to the 6-minute mark in
the REGULAR HEAVY Cycle. Pull
out the Cycle Control Knob to start
the washer.
NOTE: For best washing results, items
should move freely in the washer. Do
not overload the washer or choose a
water level that is too low for your wash
load.
l
For all rinses, the washer fills to its
highest level with cold water.
What happens in each cycle Each cycle has been designed for dif-
ferent kinds of fabrics. Numbers on the
Cycle Control Knob in each cycle are
the minutes of wash agitation time.
When the Cycle Control Knob is set
to a number and pulled out, the washer
fills before agitation and timing starts.
After agitation starts, the Cycle Control
Knob turns clockwise until it points to
OFF and the cycle ends.
NOTE: You may hear the sound of
water spraying during the spin parts of
some cycles. In all cycles, water is
sprayed on the spinning load to help
with the rinsing.
5