4.24 System board

4 Replacement Procedure

Installing the System board

To install the system board, follow the steps below and refer to Figure 4-35.

NOTE: When replacing with a new system board, stick INSU LCD CONN on the system board as shown below.

INSU LCD CONN

CN 5000

1.Connect the Bluetooth module harness to the connector CN4440 on the system board.

2.Turn over the system board and set in place.

3.Secure the system board with the following screws.

• M2.5⋅4C

FLAT HEAD

⋅3

4.Open the INSU ODD UPPER and set Bluetooth module harness under the INSU ODD UPPER to fix it.

5.Connect the SW board FFC and Touch pad FFC to the connector CN9500 and CN9550 on the system board.

TECRA R10 Maintenance Manual (960-708)

[CONFIDENTIAL]

4-61

Page 287
Image 287
Toshiba TECRA R10 manual System board Replacement Procedure, Installing the System board