
4.21 RGB HARNESS4 Replacement Procedure
4.21 RGB HARNESS
Removing the RGB HARNESS
To remove the RGB HARNESS, follow the steps below and refer to Figure
1. Remove the following screws to remove the RGB HARNESS from the slot.
• | UNIFIED screw | ⋅2 |
2.Peel the INSU RGB HNS fixing the RGB HARNESS to the
3.Disconnect the RGB HARNESS from the connector CN9510 on the system board.
RGB HARNESS
INSU RGB HNS
CN9510
Figure 4-29 Removing the RGB HARNESS
TECRA R10 Maintenance Manual | [CONFIDENTIAL] |