Toshiba TECRA R10 manual Install the Touch PAD /Fingerprint sensor board, Thin Head

4.28 TOUCH PAD/Fingerprint sensor board 4 Replacement Procedure

Install the TOUCH PAD /Fingerprint sensor board

To install the TOUCH PAD /Fingerprint sensor board, follow the steps below and refer to Figure 4-42 to 4-45.

1.Stick a new TP SPILL CUSHION on a new Fingerprint sensor board in place.

2.Stick a new D STICK TAPE TP in place.

3.Stick the Fingerprint sensor board in place on the COVER ASSY and secure it with the following screws.

• M2.0⋅4C S-THIN HEAD ⋅2

4.Set the TP BTN COV ASSY in place while engaging the latches.

5.Turn over the COVER ASSY.

6.Stick a new TOUCH PAD in place.

7.Set the TPAD PLT ASSY while engaging the latch and secure it with following screw.

• M2.5⋅4C FLAT HEAD ⋅ 1

8.Connect the TP FFC to the connector on the TOUCH PAD and Fingerprint sensor board.

9.Connect the Fingerprint sensor board FFC to the connector on the Fingerprint sensor board.

TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-73