Toshiba TECRA R10 manual Installing the DC-IN HARNESS/RJ45 Wire Harness

4.16 DC-IN HARNESS/RJ45 WIRE HARNESS 4 Replacement Procedures

Installing the DC-IN HARNESS/RJ45 WIRE HARNESS

To install the DC-IN HARNESS/RJ45 WIRE HARNESS, follow the steps below and refer to Figure 4-21 to 4-23.

1.Set the RJ45 WIRE HARNESS into the HARNESS HOLDER R.

2.Set the HARNESS HOLDER R in the slot in place and secure it with following screws.

• M2.5⋅6C FLAT HEAD screw ⋅1

3.Arrange the 3G antenna cables, Wireless LAN antenna cables, RJ45 WIRE HARNESS and CAMERA HARNESS on the HARNESS HOLDER R.

4.Connect the two 3G antenna cables to the terminals on the 3G card, RJ45 WIRE HARNESS to the connector CN4100 on the system board and CAMERA HARNESS to the connector CN9540 on the system board.

5.Stick the acetate tape in place.

6.Set the DC-IN HARNESS in the slot in place and connect the DC-IN HARNESS to the connector CN8800 on the system board.

TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-41