
4 Replacement Procedure | 4.23 Sound/USB board and MIC HARNESS |
4.23 Sound/USB board and MIC HARNESS
Removing the Sound/USB board and MIC HARNESS (Internal microphone)
To remove the Sound/USB board and MIC HARNESS, follow the steps below and refer to Figure
1. Remove the following screw securing the Sound/USB board.
• M2.0⋅4B | BIND screw | ⋅1 |
2.Disconnect the SOUND/USB HARNESS from the connector CN9520 on the system board.
3.Disconnect the SOUND/USB HARNESS, Speaker harness and MIC HARNESS from the connector CN9820, CN6180 and CN6050 on the Sound/USB board.
4.Remove the Sound/USB board from the slot.
5.Remove the MIC HARNESS from the slot.
Sound/USB HARNESS
CN6050
M2.0x4B BIND
CN6180
Speaker harness
Sound/USB board
CN9820
CN9520
MIC HARNESS
Figure 4-34 Removing the Sound/USB board and MIC HARNESS
[CONFIDENTIAL] | TECRA R10 Maintenance Manual |