4 Replacement Procedures

4.16 DC-IN HARNESS/RJ45 WIRE HARNESS

4.16 DC-IN HARNESS/RJ45 WIRE HARNESS

Removing the DC-IN HARNESS/RJ45 WIRE HARNESS

To remove the DC-IN HARNESS/RJ45 WIRE HARNESS, follow the steps below and refer to Figure 4-21 to 4-23.

1.Disconnect the DC-IN HARNESS from the connector CN8800 on the system board.

2.Remove the DC-IN HARNESS from the slot.

IDC-IN HARNESS

CN8800

Figure 4-21 Removing the DC-IN HARNESS/RJ45 WIRE HARNESS (1)

4-38

[CONFIDENTIAL]

TECRA R10 Maintenance Manual (960-708)

Page 264
Image 264
Toshiba TECRA R10 manual Removing the DC-IN HARNESS/RJ45 Wire Harness