4.7 Memory module 4 Replacement Procedures
Installing the Memory module
To install the memory module, make sure that the computer is powered off, follow the steps
below and refer to Figure 4-6 and 4-7.
NOTE: The slot A is reserved for the first memory module. Use the slot B for expanded
memory. If only one module is installed, use the slot A.
1. Insert the memory module into the memory module connector slantwise.
NOTE: Align the notch of the Memory card to the guide of the memory module
connector.
2. Press down the memory module gently until it is latched.
CAUTION: After installing the memory module, make sure that the memory module is
secured with the left and right latches.
3. Set the memory cover and secure it with two screws.
NOTE: When replacing the MEM COV ASSY with a new one, stick a caution label (LABEL
MEM COV) on it.
LABEL MEM COV
MEM COV ASSY
NOTE: When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
If the memory is not detected, check that it is connected correctly.
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-19