Toshiba TECRA R10 manual Removing the Base Assy

4 Replacement Procedures 4.11 BASE ASSY

4.11 BASE ASSY

Removing the BASE ASSY

To remove the BASE ASSY, follow the steps below and refer to Figure 4-13 to 4-15.

1.Remove the INSU LCD HNS UP from the COVER ASSY

2.Disconnect the LCD harness from the connector CN5000 on the system board.

3.Remove the following screws securing the COVER ASSY.

• M2.5⋅6C FLAT HEAD screw ⋅2

M2.5x6C FLAT HEAD

INSU LCD HNS UP

LCD harness

CN5000

Figure 4-13 Removing the BASE ASSY (1)

NOTE: The circled number shows the order to drive the screws.

4-26 [CONFIDENTIAL] TECRA R10 Maintenance Manual (960-708)