Whirlpool MT1071SG, MT1078SG Troubleshooting, Other Possible Problems And Their Causes

Models: MT1071SG MT1078SG

1 27
Download 27 pages 55.91 Kb
Page 25
Image 25
TROUBLESHOOTING

TROUBLESHOOTING

Most cooking problems often are caused by little things you can find and fix without tools of any kind. Check the lists below before calling for assistance or service. If you still need help, see the “Requesting Assistance or Service” section.

IF MICROWAVE DOES NOT OPERATE, FIRST CHECK THE FOLLOWING:

Is the microwave plugged into a live outlet with the proper voltage? (See installation instructions.) Have you blown a household fuse or tripped a circuit breaker?

Has the electric company experienced a power failure?

OTHER POSSIBLE PROBLEMS AND THEIR CAUSES:

Problem

Cause

 

 

The microwave oven

The door is not firmly closed and latched.

will not run.

You did not touch START/ENTER.

 

 

You did not follow directions exactly.

 

An operation that was programmed earlier is still running.

 

You have not entered numbers after touching COOK TIME.

Microwave cooking

The electric supply to your home or wall outlets is low or lower than normal.

times seem too long.

Your electric company can tell you if the line voltage is low. Your electrician

 

or service technician can tell you if the outlet voltage is low.

 

The cook power is not at the recommended setting.

 

Larger amounts of food need longer cooking times.

The turntable will

The turntable is not correctly in place. Make sure the turntable is correct-side

not turn.

up and is sitting securely on center shaft.

 

The support is not operating correctly. Remove turntable, check that the

 

turntable support is properly in place, and restart oven. If turntable support

 

does not move, call an authorized service technician for repair. Cooking

 

without the turntable can give you poor results.

 

 

The display shows a

The oven door is not closed completely.

time counting down but

You have set the controls as a kitchen timer. Touch OFF/CANCEL to

the oven is not cooking.

cancel the Minute Timer.

 

 

 

You do not hear the

The command is not correct.

Programming Tone.

 

 

 

The fan seems to be

The oven has been stored in a cold area. The fan will run slower until the oven

running slower than

warms up to normal room temperature.

usual.

 

 

 

The display is

There has been a power interruption. Reset the clock.

showing “:”.

 

 

 

If none of these items is causing your problem, see the “Requesting Assistance or Service” section on page 26.

25

Page 25
Image 25
Whirlpool MT1071SG, MT1078SG installation instructions Troubleshooting, Other Possible Problems And Their Causes