Using Your Mlcrowave Oven
Continued
Audible signals
Audible signals are available to guide you when setting and using your oven. A programming tone WIII sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 30 seconds after cooking is done to remind you that something has been left in the oven. Four beeps signal the end of the Minute Timer function and a Cook or Defrost cycle. If you don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone:
1. Open the door.
2. Touch CANCEL twice, then touch START.
3. Programming tones will be cancelled.
To replace the tones:
l Repeat the steps above
To remove all tones:
1. Open the door.
2. Touch CANCEL twice, touch 0, then touch
START.
3. All audible tones (including Minute Timer signal) will be cancelled.
NOTE: Do not remove all tones if you use the
Minute Timer.
To replace the tones:
l Repeat the steps above.
NOTE: If your electricity goes off, the audible signals will come back on. Repeat steps above if you want to remove them again.
Setting the clock
When the oven is first plugged in, a tone sounds and the Display shows 88:88. If the electric power ever goes off, the Display will again show all 8’s when the power comes back on.
You can cook without setting the clock, but the Display will be blank after cooking.
1. Touch CLOCK SET. The Display will show a “0” and the colon will start to flash. The first Number Pad must be touched within 5 seconds or the Display will go blank. If the Display goes blank, touch CLOCK SET again and continue.
10
