5. Electrical requirements
Observe ail governing codes and ordinances.
A 120 Volt, 60 Hz., AC only, 15 or 20 amp fused electrical supply is required. (Time-
delay fuse Is recommended.) It is recommended that a separate circuit sewing only this
appliance be provided.
6.GROUNDING | INSTRUCTIONS | |
WARNING. | Improper | use of the grounding plug can result in a risk of |
| ’ electrical | shock. |
DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER
SUPPLY CORD GROUNDING PRONG.
7.For your personal safety, this appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire forthe elec-
tric current. This appliance is equipped with a polarized
prong grounding type wall receptacle, prop-
erly installed and grounded in accordance with the National Electrical Code and local
codes | and | ordinances. | If a mating | wall recep- |
tacle | is not | available | or if you are | not sure if the |
POWER SUPPLY
CORD
I &PRONG
GROUNDING 1VPt -
-WALL PECEPlACLE
GPOUNDING | |
GP ‘OUNDING | PLUG |
731 8. Plug the oven into the proper elec- trical outlet and put about one cup (250 ml] of cold water In a olass container in the
oven. Ciose the door. Make sure it latches. Fol- low the directions on page 6 to set the oven to COOK for 2 minutes. When the time is up, the water should be heated.
wall receptacle IS properly grounded and
polarized, have it checked by a qualified electrician.
It is the personal responsibility and obligation of the customer to have a properly grounded and correctly polarized
Consult a qualified electrician if the grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly grounded.
It is NOT recommended to use an extension cord with your microwave oven, but if you find
it necessary to do so temporarily (until a pro- perly grounded and polarized
9.This microwave oven is designed for use in the household only and must not be used for
commercial purposes. . .
DO NOT remove the door, control panel, or back cover at any time. The unit is equipped with high voltage and should not be serviced unless bv an authorized Whirlbool trained serv- ice technician.
SAVE THESE INSTRUCTIONS