5. Electrical requirements
Observe all governlng codes and ordinances.
A 120 Volt, 60 Hz, AC only, 15 amp fused electrical supply is required.
recommended.] It is recommended that a separate circuit serving only this appliance be provided.
6.GROUNDING INSTRUCTIONS
7. For your personal safety, this appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire forthe elec-
tric current. This appliance is equipped with a polarized
prong grounding type wall receptacle, prop-
erly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. If a mating wall recep- tacle is not available or if you are not sure if the
GROUNDING TYPE WALL RECEPTACLE
.UG
POWER SUPPLY
CORD
73I 8. To test the oven, plug it into the proper electrical outlet. Put about one cup (250mL) of cold water in a glass container in
the oven. Close the door. Make sure it latches. Fol- low the directions on page 6 to set the oven to COOK for 2 minutes. When the time is up, the water should be heated.
wall receptacle is properly grounded and
polarized, have it checked by a qualified electrician.
It is the personal responsibility and obligation of the customer to have a properly grounded and correctly polarized
Consult a qualified electrician if the grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly grounded.
It Is NOT recommended to use an extension cord wlth your microwave oven, but if you Hnd
lt necessary to do so temporarily (unttl a pro- perly grounded and polarized
three 16 gauge (mlnlmum),copper wires. It must not be longer than 10 feet (cords longer than10 feet may affect the cooking performance of your mi- crowave oven]. The plug on the extension cord must fit into a
9.This microwave oven is designed for use in the household only and must not be used for
commercial purposes.
DO NOT remove the door, control panel, or cabinet at any time. The unit is equipped with high voltage and should not be serviced unless
by an authorized Whirlpool trained service technician.