CARING FOR YOUR COOKTOP
4.Lift out the reflector bowl. See “Cleaning chart” on page 11 for cleaning instruc- tions.
Replacing
1.Make sure all control knobs are turned off and cool before replacing surface units and reflector bowls.
2.Line up openings in the reflector bowl with the surface unit receptacle.
3.Hold the surface unit as level as possible with the terminal just started into the receptacle. Push the surface unit terminal into the receptacle.
4.When the terminal is pushed into the receptacle as far as it will go, the surface unit will fit into the reflector bowl.
NOTE: Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of the utensils may not be flat enough, or some may be too large for the surface unit. In either case, some of the heat that’s meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.
10
