Replacing
l
l
Burn, Electrlcal Shock and Fire Hazard
Make sure all surface units are OFF before replacing surface units and reflector bowls. Failure to do so can result In burns or electrical shock.
Do not llne the reflector bowls wlth foil. Fire or electrical shock could result.
. Turn off all surface units.
2.Line up openings in the reflector bowl with the surface unit recep- tacle and the element hold down clip.
II I
3.Hold the surface unit as level as possible with terminal just started into the receptacle. Push the surface unit terminal into the receptacle.
4.When terminal is pushed into the receptacle as far as it will go, push down the edge of the surface unit opposite the receptacle. The ele- ment hold down clip will keep the surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl gets dlscolored, some of the utensils may not be flat enough, or some may be too large for the surface unit. In either case, some of the heat that’s meant to go Into or around a utensil goes down and heats the reflector bowl. lhls extra heat can dlscolar it.
20
