CONVERTIBLE KITCHEN RANGE HOOD FOR 120 V. OPERATION
FOR VENTLESS INSTALLATION
USE DUCTLESS KIT RCH 4660
READ AND SAVE THESE INSTRUCTIONS
Before you begin, read the following instructions completely and carefully. If followed, they will simplify the installation job.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
KITCHEN
RANGE HOOD
MODEL
RH4300XL
SERIES
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
Your range hood has been &signed to filter out smoke, odors and grease which rise from the cooking surface. Before you begrn the installation be sure that all parts and accessories are removed from carton. For best results and ease in the installation of this range hood, read the
rnstructions sheet tobecomefamiliarwiththestep by step installatron.
YOUR HOOD CAN BE INSTALLED VENTLESS WHERE AIR IS
CIRCULATED BACK INTO THE ROOM THROUGH THE FILTER OR VENTED WHERE AIR IS TAKEN OUT OF YOUR KITCHEN.
For most efficient operation, the top of the hood should be approximately 66 inches (167.6 cm) lrom the floor. See Page 2 for examples of typical ductwork installations. Choow the best method for your installation.
<”
19;
,50.2c
IRING KNOCKOUTS
FIG. 1
REAR OF HOOD
DAMPER MOUNTING
TOOLS AND MATERIALS REQUIRED
- me:,, | ^I^ ctric | or ratchet | drive, | with | wood | bit | (to | |
. , ,scess | hole in the | cabinet | or | kitchen | wall | for | the | |
electrrc | power | line.) |
|
|
|
|
|
|
l One common head screwdrrver (to secure hood mountrng screws to the cabinet and hood sheet metal parts).
l Pliers (for openrng knockouts).
l Pencil, ruler and level for markrng cabinet locatrons.
l Saber saw or keyholesaw for Cutting the wall or cabinet openings.
l Caulking. metal snips, duct tape, ducts (with elbow and
transrtron. of necessary) and wall cap or roof cap, as required
