7.Remove the hood and start all four screws in the center Of the narrow neck of the keynole slot marked on the cabinet bottom. See Figure 2.
8.Remove proper venting knockout. If 7” (17.8 cm) round vertical venting, entire top knockout including rectangular portjon must be removed. The best performance from your hood, with most air taken from the kitchen and when the hood IS most quiet. comes when you top vent with 7” round duct pipe as shown In Figure 3.
FOR RECTANGULAR VENTING: There are predrilled holes on hood so you can attach damper to hood with small sheet metal screws Included.
9lnslall proper ductwork. For round vented installations. a round damper should be placed In the ductwork to prevent air Infiltration.
10Lift the hood Into posttlon simultaneously feeding the electrlcal wire lhrough the knockout
11TIghten four mounting screws to secure hood to cabinet. Be sure the screw heads are in the narrow neck of the keyhole slot
12Complete electrical wlrlng In the junction box according to the Natlonal Electrical Code and applicable local codes.
NOTE. This unit must be permanently grounded.
13Replace juncllon box cover
14Seal holes around ventllatlng pipe and wiring passing lhrough celling or outside wall with caulking or Insulation lo prevent heat loss
15.Be sure that damper which IS supplied with this model is properly Installed. (See Figures 3,4. 8 5).
rDlSCHAF?GE GRILL
FIG. 6
NOTE:
A.For round vertical venting, remove the entire top knockout including the rectangular portion.
B.For rectangular vertical venting, remove the 3%” x 10” rectangular knockout only.
FOR VENTLESS | / |
| |
INSTALLATION |
|
1 To convert your range hood to ventless, remove the discharge grill shown In Figure 6 by pulling with fingers. Remove the metal back seal from behind the louver.
2Replace discharge grill and secure with plastic rivets by pushing with thumb
.3. Follow Instructtons under “Vented Installattons” for wiring and mounting Omit ductwork preparations
3.Install charcoal falter from ventless kit behind aluminum filter. (See Figure 7)
LIGHT LENS
JUNCTION BOX J
COVER
FIG. 7
CHARCOAL FILTER
n
UMINUM FILTER
Page 3
