1.For vented applications, see Figures.3 4, and 5. Typical vented installations are shown for the 7” Round Vertical, 3% x 10 Vertical, and the 3% x 10 Horizontal Discharge respectively. Choose the best
2.Mark locations on cabinet or wall for ventilating duct and electrical wiring from dimensions given in Frgure 1
3Cut holes at marked locations to accomodate ventilating duct and electrrcal wiring. Allow %” (1.91 cm) extra on ventilating opening toward the front of cabinet directly above the hood. Be sure to minimize openings through outside walls or the ceiling These will have to be sealed later.
4.Run wire through wall or cabinets according to the Natronal Electrical Code and applicable local codes. DO NOT turn power on until installation is complete.
5.Remove screws holding junclion box cover See Figure 7.
6.Ltft the hood into positron and mark the hole locations on the cabinet for each of the four keyhole mounting slots.
IF RAIN CAP HAS
A DAMPER, REMOVE
DAMPER BLADE
FROM HOOD.
KEYHOLE SLOT
IN CANOPY
FIG. 4
VERTICAL VENTING
FIG. 2
(IN INSTALLATION PARTS BAG)
LOCATE AS FAR
FROM HOOD AS
POSSIBLE
FIG. 3
VERTICAL VENTING
7” ROUND
34 ’ “x IO” RECTANGULAR
IF RAIN CAP HAS
A DAMPER, REMOVE
DAMPER BLADE
FROM HOOD.
I .
I,
(16% cm)
FIG. 5
-LL==Jg I
HORIZONTAL VEN ITING
Page 2