Whirlpool RJE-3600 warranty Oven rack positions, Using the oven light, Ii I’

II I’

To remove rack, pull forward until rack stops, lift front and pull.

To replace the oven light, remove glass cover.

Oven rack positions

Your oven has two racks. Always put the racks where you want them to be before you turn on the oven.

To remove a rack, take hold of it on the front edge and pull it out until it stops. Then lift up the front edge and pull again. It will slide past the stops, out of the guides and out of the oven.

To put it back, fit the back corners into the guides at each side of the oven and slide it in, keeping the front tilted up until the rack passes the stops in the rack guides.

For:	Place Rack:
Baking	On	the	second rackguide		from	the	bottom or
	so food is in the center of the oven.
Broiling	So	food	is about	the distance		from	the broil
	element suggested in the broiling timetable
	under “Using the Oven Controls.”
Roasting LARGE	On	the	bottom	rack guides.
cuts of meat
Roasting	So	food	is in the	center	of the	oven.
SMALLER
cuts of meat

When baking, always leave at least 1% to 2 inches (4-5 cm) of air space between the sides of a pan and other pans and the oven wall for air circulation.

For best results, get additional information on placing pans, cookie sheets and other utensils from the “Cooking Guide.”

Using the oven light

The oven light will come on when the oven door is opened.

To replace the oven light bulb:

The oven light bulb has a glass cover which is held on by a wire holder. This cover must be in place when the oven is being used.

1. Turn off the electric power at the main power supply.

2 Pull out on the wire holder and move it to one side. This will let you remove the glass cover.

3.Replace the bulb with a 40-watt appliance bulb (designed to stand up to oven heat) available at most grocery, variety and hardware stores.

4.Replace glass cover. Snap the wire holder in place