Whirlpool RJE-362B manual Removing surface units and reflector bowls

I ,\ Terminal

To remove surface unit, lift and pull straight out.

Hold surface unit level when replacing.

Prop up the top with support rod.

Pull to stop. Lift; pull again.

Removing surface units and reflector bowls:

1First. be sure the Surface Unit Controls are all “OFF“and that the surface units are (001.

2Set) where the surface units plug into the range? Lift each surface unit about an inch (2 5 cm) at the edge away from the plug-In (receptacle). Pull the unit straight away from the plug-in. Do not

wash surface units; they will burn themselves clean during nor- mal use.

13 Lift out the reflector bol~ls

Replacins reflector bowls and surface units:

Be sire the surface unit controls are on “OFF”

Put the reflector bowls back into their places. Make sure you can see the plug-ins (receptacles) for the surface units through the square hole in the side of rach bowl

Hold the surface unit level with the prongs (terminals) pointing at the plug-in

With the prongs started 1nthe plug-in. start pushing in on the surface unit. At the same time. lift a little on the side of the surface unit that’s by the plug-in

5Make sure the suricice-unit prongs are pushed into the plug-in as far as they will go ThlJ surface unit will fit into the reflector bowl and be level when everything has been done right

Cleaning under the cooktop:

To clean the area under the cooktop. lift the front of the cooktop at the center Raise the swing-up rod to hold it. (Be sure the tip of the rod is in the notch In the cooktop.) Use warm soapy water and a sponge or cloth. Scouring powders or any other abrasive cleaner may harm porcelain- enamel finishes and can xratch chrome.

Be careful not tI 1 raise the cooktop so high that it touches the control console And dori t drop It. Dropplng the cooktop can chip or crack a hard porcelain finish. <jrdamage side panels and surface units.

Removing the storage drawer:

The drawer below your oven IS meant to store pots and pans. Never keep anything in there that will burn or melt.

You may want to remove the drawer for cleaning under the range. Pull it straight out until it jtops. Lift the front and pull some more to get it over the stop Now sltdcj it out until it stops again. Lift the drawer away from the range until it slips out of the guides.

To put it back. fit the side rails at the back of the drawer into both guides on the range Pu\il it closed while lifting the front to get past the stops.

13