1,j Terminal
To remove surface unit, lift and pull straight out.
Hold surface unit level when replacing.
Prop up the top with support rod.
Removing surface units and reflector bowls:
1.First. be sure the Surface Unit Controls are all “OFF“and that the surface units ari’ cool.
2.See where the surface units plug into the range’? Lift each surface unit about an Inch (2.5 cm) at the edge away from the
3.Lift out the reflector bowls.
Replacing reflector bowls and surface units:
1.Be sure the surface unit controls are on “OFF”
2.Put the reflector bowls back into their places. Make sure you can see the
3.Hold the
4.With the prong5 started In the
unit At the same time. lift a little on the side of the surface unit that‘s by the
5Make sure the
Removing and replacing upper oven rack guides
Lift the front of the rack guide. Swing it away from the oven wall far enough for the tab to get clear of the slot In the oven wall. Pull the guide straight out of the oven To put it back. fit the end of the rack guide into the hive holes in the back wall of the oven. Line up the tab on the guide with the slot !n the side wall. Push It in and push down a little to lock it in place
Cleaning under the cooktop:
To clean the area under the cooktop. lift the front of the cooktop at he center Raise the
Be careful not to raise the cooktop so high that it touches the upper oven. And don’t drop it. Dropping the cooktop can chip or crack a hard porcelain finish. or damage srde panels and surface units.
12
