READ AND SAVE THESE INSTRUCTIONS
YLrlmml
1 CORPORATION
INSTALLATION
AND
OPERATING
INSTRUCTIONS
FOR
MICROSHELF HOOD
MODEL RJH
Before you begin, read the following instructions completely and carefully. If followed, they will simplify the installation job.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
BEFORE YOU USE YOUR MICROSHELF HOOD:
Be sure your Microshelf Hood is installed on an appropriate wall strong enough tosupport this appliance.
NOTE: The shelf of the Microshelf Hood is designed to support a Microwave Oven with a net weight of up to 75 pounds.
The area used for the installation must be suitable forthe size, function, and protection (from elements) of the Microshelf Hood.
CAUTION: When mounting the Microshelf Hood to a wall, you must locate 2 studs in the wall. Do not attempt to install the hood if the 2 wall studs are not found.
Be careful when drilling holes into a wall. Electrical wires and water pipes may be concealed behind the wall covering.
APPROVED FOR USE WITH WHIRLPOOL RJM AND RHM SERIES AND THE RFM
MICROWAVE OVENS.
APPROVED FOR USE OVER WHIRLPOOL
CONVENTIONAL RANGE COOKTOPS THAT DO NOT HAVE A GRILLE.
Page
NOTE: The fan in the Microshelf Hood turns on automatically to protect the microwave oven when the temperature inside the hoodreaches 122°F (SO’C). It turns off automatically when the temperature falls below 95°F (35°C).
I. INSTALLATION REQUIREMENTS A. Space Requirements
A typical installation can be seen in Figure 1. Study Figure 1 before proceeding. The Microshelf Hood requires an opening that is 30” wide. It is recommended that the cabinet above the cooktop be a maximum of 15” high. This provides adequate space between the range cooktop and the Microshelf Hood.
|
|
| l- |
|
|
|
CEILING |
| F | 3;‘IO”. | |||
| FURR DOWN | |||||
APPROX | 96” | %I |
|
|
|
|
FROM | FLOOR |
|
|
|
|
|
|
|
| 1 | DUCT |
| |
|
|
| % | TRANSITION | ||
|
|
|
|
|
| |
|
|
|
| DUCT |
| |
FLOOR | T |
|
| PROVIDED | ||
|
|
| WITH | HOOD | ||
| t n000 | MICROWAVE |
| |||
|
|
| II | |||
| OVEN |
|
| |||
| u |
| $ | |||
| SHELF1 |
|
|
| THICK | |
|
|
|
|
| ||
| I5”MIN |
|
| SHEET | ROCK | |
| COOK | TOP? |
|
|
|
|
Figure 1
B. Electrical Requirements
A 120 Volt, 60 Hz, AC only, 20 Ampere fused electrical supply is required (time delay fuse or
circuit breaker is recommended). It is recommended that a separate circuit serving only this appliance be provided.
C. Venting Requirements
For vented installations, the venting system must terminate to the outside.
CAUTION: Do not terminate the vent in an attic or other enclosed space. This type of installation may result in a fire.
If a vertical venting system is used, using 3%” x 10” duct, the maximum length allowed is 25 feet. If elbows are used in the venting system, reduce the length of 3%” by 10” duct by 24 feet for each elbow used.
The Microshelf Hood may be centered horizontally as shown in Figure 2. The maximum length of duct run horizontally, using one 3%” x 10” elbow, is one foot
1