Using the ice cube trays
(RTlIDK, RT14GD and RT14HK)
If cubes are not used, they may shrink. The moving cokf air starts a slow evaporation. The longer cubes are stored, the smaller they get.
To remove ice:
1.Hold tray at both ends.
2.Twist slightly.
Using the automatic ice
(Optional on RT14DK, RTl4GD and
factory-installed on RT14DM)
If you have an automatic ice maker, or if you plan to add one later (Part No. IMKIT), here are a few things you will want to know:
l For models RT14DK, RT14GD and RT14HK: The aluminum water inlet tube, supplied with your refrigerator, is in the bottom rear of the refrigerator, on the compressor support plate. Use this tube instead of the tube provided in the acces-
sory kit. | , |
|
lThe ON/OFF lever is a wire signal arm.
DOWN to make ice automatically UP to shut off the ice maker
IMPORTANT: Do not turn on the ice maker until it is connected to the water supply. Instructions for ke maker water supply hook up are attached to the back of the refrigerator cabinet.
lThe dial or lever on the side of the ice maker changes the size of the cubes.
l You may hear water running when the ice | l |
maker is working. You’ll hear ice falling |
|
into the bin. Don’t let these sounds bother |
|
you. |
|
lIf you remove the ice bin, raise the signal arm to shut off the ice maker. When you replace the bin, push it in all the way and lower the ice maker signal arm to the ON position.
maker
RT14HK,
LIP to stop he maker.
[IOWN to start ii::e maker.
Good water quality is important for good it23 quality. Try to avoid connecting the ice maker to a soflened water supply. Water s( bftenerchemicals (such as salt from a malfunctioning softener) can damage the icl3 maker mold and lead to poor ice q1lality. lf a softened water supply cannot bc! avoided, make sure the water softener is operating properly and well maintained.
9