4.If ports are clogged, clean with a straight pin. Do not enlarge or distort port. Do not use a wooden toothpick. If adjustment Is needed, call a qualified technician for service.
5.After cleaning the gas tube opening and ports, replace the burner cap.
6.Turn on the burner to determine if it will light. If the burner does not light after cleaning, contact an authorized Whirlpool service technician. Do not service the sealed burner yourself.
Cleaning chart
Use the following table to help you clean all parts of your cooktop.
PART
Control knobs
Control panel and trim
Cooktop surface
(other than control panel)
Surface burners, grates, caps, and contoured well area
WHAT TO USE
Sponge and warm, soapy water
Sponge and warm, soapy water
OR
Paper towel and spray glass cleaner
Sponge and warm, soapy water
|
|
| HOW TO CLEAN |
l | Turn | knobs | to OFF and pull straight away |
| from | control | panel. |
l | Wash, rinse | and dry thoroughly. Do not soak. | |
lDondusesteelwoolorabmslvecleansers.
Theymaydamagethefinishoftheknobs.
l Replace knobs. Make sure all knobs point to OFF.
l Wash, rinse and dry thoroughly.
l Be sure to wring excess water from sponge before wiping around controls. Excess water in or around controls may cause damage to the cooktop.
lDonotueesteelHlodorabrasivecleansers. They may damgta the finish.
l Do not spray cleaner directly on panel. Apply cleaner to paper towel.
l Wash, rinse and dry thoroughly.
l Use nonabrasive, plastic scrubbing pad on heavily soiled areas.
l Do not use abrasive or harsh cleansers. They may damage the finish.
NOTE: Do not allow foods containing acids (such as vinegar, tomato or lemon juice) to remain on surface. Acids may remove the glossy finish. Also wipe up milk or egg spills when
See pages
12
