Lift-up cooktop
1.Remove surface burner grates.
2.Lift front of cooktop at both front corners until the support rods lock into place.
Personal Injury and Product
Damage Hazard
l Be sure both support rods are fully ex- tended and in the locked position. Failure to do so could result in personal injury from the cooktop accidentally falling.
*Do not drop the cooktop. Damage can result to the porcelain and the cooktop frame.
3.Wipe with warm, soapy water. Use a soapy
NOTE: When cleaning under the cooktop on standing pilot models, be careful not to extinguish pilots.
4.To lower the cooktop, lift cooktop from both sides while pressing the support rods back to unlock them. Lower the cooktop into place.
Replace surface burner grates.
Surface burners
1.Lift up the cooktop, following the instructions above.
2.Before cleaning, remove screws that hold each of the burners in place. The screws prevent the burners from moving during shipment. Remove the shipping screws with a Phillips screwdriver, lift the burner up, tilt it to one side at the end closest to the ignitor and move it toward the back of the range. This separates the burner from the gas valve at the front of the range, so it can be easily removed.
3.Wipe off surface burners with warm, soapy water and a sponge after each use. To remove
4.If ports are clogged, clean with a straight pin. DO NOT enlarge or distort the ports. DO NOT use a toothpick to clean the ports.
