10
USING YOUR RANGE
1. Press CLOCK. The colon flashes during
clock programming.
2. Set the time.
Press the “up” (▲) or “down” (▼) pad(s) until
the correct time shows on the display.
NOTE: Press a pad briefly to change time by a
small amount. Press and hold a pad to change
time by 10 minute increments.
3. Press CLOCK again to start the clock. The
colon stops flashing when the clock is active.
THE ELECTRONIC TIME-OF-DAY (TOD)CLOCK/TIMER
SETTING THE CLOCK
CLOCK
TIMER TIMER
Oven
timer pad
(p. 11)
Display/clock
•When you first plug in the range, the display
flashes time-of-day. If, after you set the clock
(see “Setting the clock” section), the display
flashes, your electricity was off for a while. Reset
the clock.
•When showing the time of day, the display will
show the hour and minutes.
Electronic display
Clock
pad
(p. 10)
Increase
pad
(p. 10, 11)
Decrease
pad
(p. 10, 11)
•When you are using the timer, the display
will show seconds for time less than 1 minute,
minutes for time less than 1 hour, and hours
and minutes for time over 1 hour. The timer
indicator will be lit when in the timer mode.
PRESS YOU SEE
PRESS YOU SEE
PRESS YOU SEE