Adjusting the oven temperature control
Oven temperature controls will gradually shift after years of use. So, even though your new oven is properly adjusted to provide accurate temperatures, it may cook faster or slower than your old oven.
If, after using the oven for a period of time, you are not satisfied with the temperature settings, you can adjust them by following these steps:
1.Push in and turn the Oven Temperature Control Knob to the off position. Pull knob straight off and flip it over.
2.Loosen the locking screws inside the control knob. Note the position of the notches.
3.To lower the temperature, hold knob handle firmly and move the tooth a notch clockwise. Each notch equals about 10°F (5°C).
4.To raise the temperature, hold knob handle firmly and move the tooth a notch counter- clockwise. Each notch equals about 10°F (5°C).
Tighten the locking screws and replace the control knob.
Locking screw0
To raise
Broiling
The broiler drawer is located below the oven door. Always broil with the oven door closed.
1.Pull the broiler drawer open and tilt the door panel down.
2. Place broiler pan | grid so | grease | can drain | Drain slot | Rib | Front |
down ribbing and | through | slots | into lower | part |
|
|
of the broiler pan. See picture. |
|
|
|
| ||
3.Before the broiler is turned on, place food on broiler pan and position the broiler pan at
one of the three levels. Refer to a reliable |
|
cookbook for broiling chart. | Side view |
14
