Whirlpool SF314PSY manual Lift-up cooktop, Surface burners

Lift-up cooktop

1.Remove surface burner grates and reflector pans.

2.Lift front of cooktop at both front corners until the support rods lock into place.

l

l

Personal Injury and Product

Damage Hazard

Be sure both support rods are fully ex- tended and in the locked position. Failure to do so could result in personal injury from the cooktop accidentally falling.

Do not drop the cooktop. Damage can result to the porcelain and the cooktop frame.

3.Wipe with warm, soapy water. Use a soapy steel-wool pad on heavily soiled areas.

NOTE: When cleaning under the cooktop, be careful not to extinguish pilots.

4.To lower the cook-top, lift cooktop from both sides while pressing the support rods back to unlock them. Lower the cooktop into place.

Surface burners

1.Lii up the cook-top, following the instructions above.

2.Before cleaning, remove screws that hold each of the burners in place. The screws prevent the burners from moving during shipment. Remove the shipping screws with a Phillips screwdriver, lift the burner up, tilt it to one side at the end closest to the ignitor and move it toward the back of the range. This separates the burner from the gas valve at the front of the range, so it can be easily removed.

3.Wipe off surface burners with warm, soapy water and a sponge after each use. To remove cooked-on food, soakthe burners in a vinegar and water solution for 20-30 minutes. Scrub with a plastic scrubbing pad.

4.If ports are clogged, clean with a straight pin. DO NOT enlarge or distort the ports. DO NOT use a toothpick to clean the ports.

18