Caring for your washer
To keep your washer looking like new:
lWipe up detergent, bleach or other spills with a soft, damp cloth as they occur.
lSharp or heavy objects should not be put on or in the washer. Check pockets for bolts, nuts, etc.
lIf the washer interior needs cleaning, put 1 cup (250 mL) of chlorine bleach and 2 cups (500 mL) of detergent in the washer. Run through a complete cycle using hot water.
l When removing hard water deposits, use only cleaners labeled as being washer safe.
l After tinting or dyeing, put chlorine bleach and detergent in the washer. Run through a complete cycle using hot water to remove excess dye or tint. If staining occurs on following loads, repeat the process.
Saving energy
lUse hot water only when washing heavy, greasy soils or whites.
. Use cold rinses.
lWash full loads.
lUse lower water levels when washing small loads.
l
l
Avoid rewashing. Use enough detergent; pretreat stains or heavy soils; do not over- load; use the cycles and wash times recom- mended for the fabric and soil; sort properly.
Use your washer during
Winterizing your washer
Install and store your washer where it will not freeze. Because some water stays in the washer, freezing can damage it. If your washer is stored or moved during freezing weather, winterize it.
1.Shut off both water faucets. Disconnect the drain water inlet hoses.
2.Put 1 quart (1 L) of
3.Run washer on a drain and spin setting for about 30 seconds (see page 8) to mix antifreeze and water.
To use the washer agaln ...
1.Flush water pipes and hoses.
2.Reconnect water inlet hoses.
3.Turn on both water faucets.
4.Run the washer through a complete cycle with 1 cup (250 mL) of detergent to clean out antifreeze.
20
