4.Use saber or keyhole saw to cut the circular vent opening.
Circular vent opening
*5" |
(12.7 cm) |
Install Range Hood
NOTE: Your model will have a 3¼" x 10" (8.3 x 25.4 cm) rectangular vent damper on the inside of the range hood.
1. Remove the 3¼" x 10" (8.3 x 25.4 cm) rectangular vent damper attached with 3.5 x 9.5 mm screws on the inside your range hood. Use these screws to install the rectangular vent damper.
Cabinet cutouts
*From wall, not cabinet frame
Style 3 - Cut Openings for 7" (17.8 cm) Round Vent
To make a circular vent openings on the underside of the cabinet top and bottom:
1.Mark a centerline on the underside of the top of cabinet.
2.Mark a line 5" (12.7 cm) from the back wall on the underside of the top and bottom of cabinet.
3.Use a compass or a circle template to draw a circle with a diameter that is ¼" (0.64 cm) larger than the vent.
4.Use saber or keyhole saw to cut the circular vent opening.
*5" |
|
(12.7 cm) | 7 ¹/₄" (18.4 cm) diam. |
| cabinet cutouts |
A
B
A. 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular vent damper
B. 3.5 x 9.5 mm screws
2.Lift the range hood up under cabinet and determine final location by centering beneath cabinet. Mark on the underside of cabinet the location of the 4 keyhole mounting slots on the range hood. Set range hood aside on a covered surface.
A
*From wall, not cabinet frame
A. Keyhole slot
3. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.
Install Vent System
1.Install vent through the vent opening in upper cabinet or wall. Complete venting system according to the selected venting method. See “Venting Requirements” section.
2.Use caulking to seal exterior wall or roof opening around the cap.
A
A. Drill pilot hole.
4.Install the 4 - 4.5 mm x 13 mm mounting screws in pilot holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads and cabinet to slide range hood into place.
¹⁄₄"
(6.4 mm)
9
