SecuretheDrainHose
1.Remove the shipping strap from the power cord. Drape the power cord over the console.
2.Remove any cardboard used to move washer.
Beaded tie strap
3.Wrap the drain hose to the laundry tub leg or drain standpipe with the beaded tie strap. Push fastener into the nearest hole in the beaded tie strap. See view A or B.
ABC
If the washer faucets and the drain standpipe are recessed, put the formed end of the drain hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the drain hose. See view C.
LeveltheWasher
Properly leveling your washer avoids excessive noise and vibration.
Install the Front Leveling Feet
1.Prop up the front of the washer about 10.2 cm (4") with a wood block or similar object. The block needs to support the weight of the washer.
10.2 cm (4")
A
A. Threaded holes for feet
2.Screw the locknut onto each foot to within 2.5 cm (1") of the foot base.
2.5 cm
(1")
3.Screw the feet into the threaded holes at the front corner of the washer until the nuts touch the washer. Twist the feet to install.
NOTE: Do not tighten the nuts until the washer is level.
4.Tilt the washer back and remove the wood block. Gently lower the washer to the floor.
Steps in Final Location
1.Slide the washer to its final location.
2.Tilt the washer forward until the rear of the washer is at least 10.2 cm (4") off the floor. You may hear the
10.2 cm (4")
A
A.
3.Check the levelness of the washer by placing a level on the top edges of the washer, first side to side, then front to back.
15
