4.If the washer is not level, move the washer out slightly, tip back, prop up the front of the washer with the wood block and adjust the feet up or down as necessary by twisting the feet. Turn the feet clockwise to raise the washer or counterclockwise to lower the washer. Repeat steps
1 through 4 until washer is level.
5.After the washer is in its final location and level, use a 14 mm or ⁹⁄₁₆"
IMPORTANT: If the nuts are not tight against the washer cabinet, the washer may vibrate.
CompleteInstallation
1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended earthing method. See “Electrical Requirements.”
2.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
3.Check that you have all of your tools.
4.Check that the yellow shipping strap was completely removed from the lower back of the washer.
5.Dispose of/recycle all packaging materials.
6.Check that the water faucets are on.
7.Check for leaks around faucets and inlet hoses.
WARNING
Electrical Shock Hazard
Electrically earth this appliance.
Do not use an extension cord or an electrical portable outlet device.
Failure to follow these instructions can result in death, fire, or electrical shock.
8.Plug into an earthed outlet.
9.Remove the protective film on the console and any tape remaining on the washer.
10.Read “Washer Use” in the Washer User Instructions.
11. To test and to clean your washer, measure ¹ of the normal recommended amount of powdered or liquid detergent and pour it into the washer basket or detergent dispenser (on some models). Close the lid. Select any cycle, and then pull the cycle control knob out to start the washer. Allow it to complete one whole cycle.
| 4/06 |
W10038070 | Printed in U.S.A. |
© 2006 Whirlpool Corporation. | Benton Harbor, Michigan 49022 |
