Whirlpool W10097001A-SP Location Requirements, Parts supplied all models, Parts needed

	If using a power supply cord:
	Use a UL listed power supply cord kit marked for use with
	clothes dryers. The kit should contain:
	■■	A UL listed 30-amp power supply cord, rated 120/240 volt
		minimum. The cord should be type SRD or SRDT and be
		at least 4 ft. (1.22 m) long. The wires that connect to the
1/4" nut driver	Vent clamps	dryer must end in ring terminals or spade terminals with
		upturned ends.
(recommended)
	■■	A UL listed strain relief.

Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench

Utility knife

Location Requirements

Tape measure

Level

Pliers

Caulking gun and compound (for installing new exhaust vent)

You will need:

■■	A location allowing for proper exhaust installation.
	See “Venting Requirements.”
■■ A separate 30 amp circuit.
■■	If you are using power supply cord, a grounded electrical
	outlet located within 2 ft. (610 mm) of either side of dryer.
	See “Electrical Requirements.”
■■	A sturdy floor to support the total weight (dryer and load)
	of 200 lbs. (90.7 kg). The combined weight of a companion

Parts supplied (all models):

Leveling legs (4)

Parts package is located in dryer drum. Check that all parts are included.

Parts needed:

Check local codes. Check existing electrical supply and venting, and read “Electrical Requirements” and “Venting Requirements” before purchasing parts.

Mobile home installations require metal exhaust system hardware, available for purchase from the dealer from whom you purchased your dryer. For further information, please reference the “Assistance or Service” section of the Dryer

User Instructions.

appliance should also be considered.

■■ Level floor with maximum slope of 1" (25 mm) under entire

dryer. (If slope is greater than 1" [25 mm], install Extended

Dryer Feet Kit, Part Number 279810.) If not level, clothes

may not tumble properly and automatic sensor cycles may

not operate correctly.

Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.

Installation clearances:

The location must be large enough to allow the dryer door to open fully.

3