Complete Installation
Electronic Ignition System
Initial lighting and gas flame adjustments
Surface burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues, as long as the control knob is turned to “LITE.”
Check Flame Height
Adjust the height of surface burner flames.
The surface burner “low” flame should be a steady blue flame approximately ¼" (0.64 cm) high.
A
Check Operation of Surface Burners
Push in and turn the surface burners control knobs to the “LITE” position.
The surface burner flame should light within 4 seconds. The first time a surface burner is lighted it may take longer then 4 seconds to light because of air in the gas line.
Check the flame on “HI” for a blue color. It should be clean and soft in character. No yellow tip, blowing or lifting of flame should occur. Occasional orange flashes are normal and reflect different elements in the air or gas.
After verifying the proper burner operation, turn the control knobs to “OFF.”
If burners do not light properly:
■Turn surface burner control knob to the “OFF” position.
■Check that the power supply cord is plugged in and the circuit breaker has not tripped or the fuse blown.
■Check that the gas shutoff valves are set to the “open” position.
■Check that burner caps are properly positioned on burner bases.
Recheck operation of surface burners. If a burner does not light at this point, contact your dealer or authorized service company for assistance.
B
A.Low flame
B.High flame
If the “low” flame needs to be adjusted:
The flame can be adjusted using the adjustment screw in the center of the valve stem. The valve stem is located directly underneath the control knob.
A
A. Adjustment screw in center of valve stem
1.Remove the control knob.
2.Hold the knob stem with a pair of pliers. Use a small flat- blade screwdriver to turn the screw located in the center of the control knob stem until the flame is the proper size. Turn the screw clockwise to decrease the flame height or counterclockwise to increase the flame height.
3.Replace the control knob.
4.Test the flame by turning the control from “LO” to “HI,” checking the flame at each setting.
10
