3.Apply masking tape to the end of a ⁵⁄₁₆" nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside.
C
A
D
B
A.Orifice spud
B.Orifice spud holder
C.Screw
D.Spark electrode
4.Gas orifice spuds are stamped with a number on the side. Replace the LP gas orifice spud with the correct Natural gas orifice spud.
XXX | A |
|
A. Stamped number
Refer to the following chart for the correct Natural gas orifice spud placement.
Natural Gas Orifice Spud Chart
Burner Rating | Color | Size | ID |
|
|
| Number |
|
|
|
|
17,000 BTU | Red/Magenta | 2.10 mm | N210 |
15,500 BTU | Red/Black | 2.00 mm | N200 |
14,200 BTU | Red/Orange | 1.90 mm | N190 |
13,000/13,500 BTU | Red/Blue | 1.85 mm | N185 |
12,000/12,500 BTU | Red/Yellow | 1.80 mm | N180 |
9,500 BTU | Red/Brown | 1.55 mm | N155 |
8,000 BTU | Red/White | 1.40 mm | N140 |
5,000 BTU | Red/Brass | 1.10 mm | N110 |
|
|
|
|
NOTE: Refer to the Model Number and Serial Number Plate located behind the left side of the storage or warming drawer for proper sizing of spuds for each burner location.
5.Place LP gas orifice spuds in plastic parts bag for future use and keep with package containing literature.
6.Replace the burner base using both screws.
7.Replace burner cap.
8.Repeat steps
To Convert Oven Bake Burner
1.Remove oven racks.
2.Use a ½" combination wrench to loosen the orifice hood away from the pin (about 2 to 2½ turns). The oven bake burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Bake Burner Flame” in the “Electronic Ignition System” section.
A
B
A
A
A. Orifice hood
B. Pin
To Convert Oven Broil Burner
Use a ½" combination wrench to loosen the orifice hood away from the pin (about 2 to 2½ turns). The oven broil burner flame cannot be properly adjusted if this conversion is not made. See “Adjust Oven Broil Burner Flame” in the “Electronic Ignition System” section.
A 
B
A. Lock screw
B. Orifice hood
Complete Installation
1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.
2.Refer to the “Electronic Ignition System” section for proper burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
Checking for proper cooktop, bake and broil burner flame is very important. Natural gas flames do not have yellow tips.
3.Refer to “Complete Installation” in the “Installation Instructions” section of this manual to complete this procedure.
15
