Whirlpool W10343810A Door Features, Door Rails, Door Bins, Utility Compartment and Can Caddy

Frozen Food Storage Guide

Storage times will vary according to the quality and type of food, the type of packaging or wrap used (should be airtight and moisture-proof), and the storage temperature. Seal the package or container securely to avoid taste and odor transfer throughout the product. Ice crystals inside a sealed package are normal. This simply means that moisture in the food and air inside the package have condensed, creating ice crystals.

Put no more unfrozen food into the freezer than will freeze within 24 hours (no more than 2 to 3 lbs of food per cubic foot [907 to 1,350 g per L] of freezer space). Leave enough space in the freezer for air to circulate around packages. The freezer door must close tightly.

NOTE: For more information on preparing food for freezing, check a freezer guide or reliable cookbook.

DOOR FEATURES

Your model may have some or all of these features.

Door Rails

The door rails may be removed for easier cleaning.

Snap on Door Rails on some models)

To remove and replace the rails:

1.Remove the door rails by pushing in slightly on the front of one end of the bracket while pulling out on the inside tab. Repeat these steps for the other end.

2.Replace the rails by aligning the ends of the brackets with the buttons on the sides of the door liner. Firmly snap bracket and assembly onto the tabs above the shelf as shown.

Style 1 - Door Rails

Style 2 - Trivets

Door Bins

(on somemodels)

To remove and replace the racks/bins:

1.Remove the rack/bin by lifting it and pulling it straight out.

2.Replace the rack/bin by sliding it in above the desired support and pushing it down until it stops.

Utility Compartment and Can Caddy

(on somemodels)

To remove and replace the utility compartment:

1.Remove the utility compartment by raising and holding the cover up while lifting the utility compartment up and pulling it straight out.

2.Replace the utility compartment by sliding it in above the desired support and pushing it down until it stops.

To remove and replace the can caddy:

1.Hold the can caddy with one hand and pull up until it is released from the door liner. Then, pull up on the caddy again, until the stoppers have been overcome.

2.Pull the can caddy straight out to remove it from the door.

3.Replace the can caddy by aligning the grooves on the sides with the pins in the door liner. Push up on the bottom of the caddy until the stoppers have been overcome, and slide it fully into the compartment.

13