Style 2 - Air Filter Status on Electronic Control Display
The control panel displays the Air Filter status.
■GOOD - The air filter LED does not light up.
■REPLACE - The air filter LED lights up constantly when the refrigerator door is open.
■EXPIRED - The air filter LED lights up constantly and flashes when the refrigerator door is open.
After replacing the air filter, press and hold FILTERS RESET for
3 seconds. The filter icons will turn off. See “Using the Control(s).”
NOTE: At any filter status, pressing and holding FILTERS RESET for 3 seconds will reset the air filter status to good and the air filter LED will turn off.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months, or when the status indicator air filter icon LED turns on and starts flashing when the refrigerator door is opened.
To order a replacement air filter, contact us using the assistance/service information following the warranty.
1.Remove the old air filter by squeezing in on the side tabs.
2.Remove the old status indicator.
3.Install the new air filter and reset the status indicator using the instructions in the previous sections.
REFRIGERATOR USE
Using the Controls
The temperature controls are located at the top front of the refrigerator or freezer compartments.
Temperature Controls
For your convenience, the temperature controls are preset at the factory. When you first install your refrigerator, make sure the controls are still set to the recommended setting as shown.
Style 1 - Electronic
Recommended Setting “3 Snowflakes”
Style 2 - Dial
Recommended Setting “3 Snowflakes”
IMPORTANT:
■The recommended setting should be correct for normal household refrigerator use. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm.
■Wait 24 hours for your refrigerator to cool completely before adding food. If you add food before the refrigerator has cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature controls to a colder than recommended setting will not cool the compartments any faster.
■If the temperature is too warm or too cold in the refrigerator or freezer, first check the air vents to be sure they are not blocked before adjusting the controls.
Adjusting Controls
If you need to adjust the temperature in either the refrigerator or freezer compartment, use the settings listed in the chart below as a guide.
Style 1 - Press the TEMP button to display the desired number of snowflakes from (1 least cold to 4 coldest).
Style 2 - Move the dial to the desired number of snowflakes from (1 least cold to 5 coldest).
NOTE: Except when starting the refrigerator, do not adjust either control more than one setting at a time. Wait 24 hours between adjustments for the temperature to stabilize.
CONDITION/REASON: | ADJUSTMENT: |
|
|
REFRIGERATOR too warm | REFRIGERATOR Control |
| one setting higher |
|
|
FREEZER too warm/too little ice | FREEZER Control one |
| setting higher |
|
|
REFRIGERATOR too cold | REFRIGERATOR Control |
| one setting lower |
|
|
FREEZER too cold | FREEZER Control one |
| setting lower |
Cooling Off/On
Style 1 - Press and hold TEMP for 3 seconds to turn cooling off. To turn cooling back on, press and hold TEMP again for
3 seconds.
Style 2 - Move the dial control to the word OFF. To turn cooling back on, move the dial control to the desired temperature setting.
NOTE: Neither compartment will cool when the control is set to OFF.
Additional Features
Filters Reset (on some models)
The Filters Reset control allows you to restart the filter status tracking feature each time you replace the air filter or water filter.
■Press and hold FILTERS RESET for 3 seconds. The filter icons will turn off. See “Install Air Filter” and “Water Filtration System.”
10
