■Touch any control button on the dispenser panel to activate the display screen.
■To turn cooling back on. Press and hold both TEMPERATURE buttons at the same time for 3 seconds. When cooling is on, “Cooling Off” will disappear from the display screen.
Adjusting the Controls
For your convenience, the temperature control is preset at the factory. When you first install your refrigerator, make sure that the control is still set to the recommended temperature setting
(3 snowflakes), as shown.
If you need to adjust the temperature in either the refrigerator or freezer compartment, use the settings listed in the following chart as a guide.
■Wait at least 24 hours between adjustments. Recheck the temperatures before other adjustments are made. The single temperature control ranges from 1 snowflake (least cold) to 5 snowflakes (coldest). When adjusting temperature set points, use the following chart as a guide.
CONDITION: | TEMPERATURE |
| ADJUSTMENT: |
|
|
REFRIGERATOR or FREEZER | Press the |
too cold | TEMPERATURE button to |
| adjust the temperature |
| one setting |
| less cold (2 snowflakes) |
|
|
REFRIGERATOR or FREEZER | Press the |
too warm | TEMPERATURE button to |
| adjust the temperature |
| one setting |
| colder (4 snowflakes) |
|
|
Additional Features
Door Open Alarm
■The Door Open icon lights up whenever either door is opened.
■When either door is open for 5 minutes and cooling is on, an alert tone will sound three times, and the Door Open icon will flash seven times. This pattern will repeat every 2 minutes until all the doors are closed properly. The feature then resets and will reactivate when either door is left open again for
5 minutes.
NOTES:
■To mute the audible alarm while keeping the doors open, such as while cleaning the inside of the refrigerator, press any button on the control panel. The alarm sound will be temporarily turned off, but the Door Open icon will still be displayed on the dispenser control panel.
■Both doors must be fully closed to turn off the Door Open icon.
Fast Cool
The fast cool feature assists during times of high refrigerator use, full grocery loads or temporarily warm room temperatures.
■Press FAST COOL to set the freezer and refrigerator to the coldest temperature settings. Press FAST COOL again to return to the selected temperature set point.
NOTES:
■The Fast Cool icon will be illuminated while the refrigerator is in Fast Cool mode.
■The Fast Cool feature will turn off automatically after 24 hours.
Cooling On/Off
Your refrigerator and freezer will not cool when cooling is turned off.
■To turn cooling off, press and hold both TEMPERATURE buttons at the same time for 3 seconds. When cooling is off, “Cooling Off” will appear on the display screen.
Water Filter Status Light and Reset
The filter reset control allows you to restart the water filter status tracking feature each time you replace the water filter. See “Water Filtration System.”
■Press and hold WATER FILTER for 3 seconds, to reset the water filter status to Good. The water filter LED will turn blue.
Air Filter Status Light and Reset
The filter reset control allows you to restart the water filter status tracking feature each time you replace the water filter. See “Install Air Filter.”
■Press and hold AIR FILTER for 3 seconds, to reset the air filter status to Good. The air filter LED will turn blue.
11
