INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools needed
■ | The cooktop should be installed in a location away from |
| strong draft areas, such as windows, doors and strong |
| heating vents or fans. |
■ | All openings in the wall or floor where cooktop is to be |
| installed must be sealed. |
■Tape measure
■
■³⁄₃₂" (#0 [2 mm])
■¹⁵⁄₁₆" combination wrench
■Pipe wrench
■Wrench or pliers
■
■Marker or pencil
■
■Noncorrosive
■ Cabinet opening dimensions that are shown must be used. |
Given dimensions are minimum clearances. |
■ Grounded electrical supply is required. See “Electrical |
Requirements” section. |
■ Proper gas supply connection must be available. See “Gas |
Supply Requirements” section. |
■ The cooktop is designed to hang from the countertop by its |
side flanges. |
■ The gas and electric supply should be located as shown in |
Parts supplied
■Gas pressure regulator
■Burner grates
■Burner caps
■Clamping brackets (2)
■2¹⁄₂" (6.4 cm) clamping screws (2)
Parts needed
Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See “Electrical Requirements” and “Gas Supply Requirements” sections.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air.
■It is the installer’s responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the underside of the cooktop base.
A
A. Model/serial rating plate
■To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.
“Installation Clearances” section so that they are accessible |
without requiring removal of the cooktop. |
■ Provide cutout in right rear corner of cutout enclosure as |
shown to provide clearance for gas inlet, power supply cord, |
and to allow the rating label to be visible. |
IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage.
Product Dimensions
A
B
C
A. 30³⁄₁₆" (76.7 cm) on 30" (76.2 cm) models, 36¹⁄₄" (92.0 cm) on 36" (91.4 cm) models
B. 21" (53.3 cm) C. 3" (7.6 cm)
4
