In the State of Massachusetts, the following installation instructions apply:
■Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts.
■If using a ball valve, it shall be a
■A flexible gas connector, when used, must not exceed 3 feet.
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install
Slide range back so rear range foot is engaged in the slot of the
Do not operate range without
Failure to follow these instructions can result in death or serious burns to children and adults.
Bracket
Range Foot
To verify the
•Slide range forward.
•Look for the
•Slide range back so rear range foot is under
•See installation instructions for details.
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Parts supplied
Check that all parts are included.
Tools needed
■Tape measure
■
■Phillips screwdriver
■Level
■Hand or electric drill
■Hammer
■Wrench or pliers
■Pipe wrench
■¹⁵⁄₁₆" combination wrench
■¼" drive ratchet
■³⁄₈" nut driver
■¹⁄₈" (3.2 mm) drill bit (for wood floors)
■Marker or pencil
■
■Noncorrosive
For LP/Natural Gas
Conversions
■³⁄₈" combination wrench
■½" combination wrench
■⁵⁄₈" combination wrench
■7 mm (⁹⁄₃₂") nut driver
■Quadrex®† or Phillips screwdriver
■Masking tape
A
B
A.
B.#12 x 1⁵⁄₈" screws (2)
■
Parts needed
Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See “Electrical Requirements” and “Gas Supply Requirements” sections.
†® QUADREX is a registered trademark of NLW Holdings, Inc.
3