Style 2 - Trivets
Door Bins
(on some models)
To remove and replace the racks/bins:
1.Remove the rack/bin by lifting it and pulling it straight out.
2.Replace the rack/bin by sliding it in above the desired support and pushing it down until it stops.
Utility Compartment and Can Caddy
(on some models)
To remove and replace the utility compartment:
1.Remove the utility compartment by raising and holding the cover up while lifting the utility compartment up and pulling it straight out.
2.Replace the utility compartment by sliding it in above the desired support and pushing it down until it stops.
To remove and replace the can caddy:
1.Hold the can caddy with one hand and pull up until it is released from the door liner. Then, pull up on the caddy again, until the stoppers have been overcome.
2.Pull the can caddy straight out to remove it from the door.
3.Replace the can caddy by aligning the grooves on the sides with the pins in the door liner. Push up on the bottom of the caddy until the stoppers have been overcome, and slide it fully into the compartment.
Ice Maker
(on some models)
IMPORTANT: For models with a water filter, after connecting the refrigerator to a water source or replacing the water filter, fill and discard three full containers of ice to prepare the water filter for use.
Turning the Ice Maker On/Off
To turn the ice maker ON, simply lower the wire shutoff arm.
To manually turn the ice maker OFF, lift the wire shutoff arm to the OFF (arm up) position and listen for the click.
NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. Do not force the wire shutoff arm up or down.
Ice Storage Bin
1.Wash the ice storage bin with mild soap and warm water.
2.Slide the ice storage bin under the ice maker, and push it toward the back as far as it will go.
3.Lower the arm on the ice maker to the “on” position.
NOTE: It usually takes approximately 24 hours for the ice maker to begin producing ice. You may notice the ice has an
Ice Production Rate
■The ice maker should produce approximately 8 to 12 batches of ice in a
■To increase ice production, lower the freezer and refrigerator temperature. See “Using the Control(s).” Wait 24 hours between adjustments.
Remember
■The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.
■Do not use anything sharp to break up the ice in the bin. This can cause damage to the ice storage bin and the dispenser mechanism.
■Do not store anything on top of or in the ice maker or ice storage bin.
16
