DoorClosing
Door Closing
Your wine cellar has four leveling legs. If your wine
cellar seems unsteady or you want the door to close more easily, adjust the wine cellar’s tilt using the instructions below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet. Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
1.Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
2.Move the wine cellar into its final location.
3.Turn the leveling legs to the right to lower the wine cellar or turn the leveling legs to the left to raise it. It may take several turns of the leveling legs to adjust the tilt of the wine cellar.
NOTE: Having someone push against the top of the wine cellar takes some weight off the leveling legs. This makes it easier to adjust the leveling legs.
4.Open the door and check to make sure that it closes as easily as you like. If not, tilt the wine cellar slightly more to the rear by turning both front leveling screws to the right. It may take several more turns, and you should turn both leveling legs the same amount.
WINE CELLAR USE
NormalSounds
Your new wine cellar may make sounds that your old one didn’t make. Because the sounds are new to you, you might be concerned about them. Most of the new sounds are normal. Hard surfaces, such as the flooring and surrounding structures, can make the sounds seem louder. The following describes the kinds of sounds and what may be making them.
Your wine cellar is designed to run more efficiently to keep your stored items at the desired temperatures and to minimize energy usage. The high efficiency compressor and fans may cause your wine cellar to run longer than your
old one. You may also hear a pulsating or
Rattling noises may come from the flow of refrigerant or items stored inside the wine cellar.
As each cycle ends, you may hear a gurgling sound due to the refrigerant flowing in your wine cellar.
You may hear water running into the drain pan when the wine cellar is defrosting.
You may hear clicking sounds when the wine cellar starts or stops running.
UsingtheControl
The wine cellar has an electronic control panel that allows total cabinet temperature control. It also offers the option of displaying and setting the temperature in Fahrenheit or Celcius.
Adjusting Controls
To adjust the temperature on the wine cellar, press the up or down arrow once to enter the SET mode. The temperature display will flash to let you know that the temperature can be adjusted.
To make the wine cellar cooler, press the down button until the desired temperture is reached.
To make the wine cellar less cool, press the up button until the desired temperature is reached.
Each depression of the up or down arrow will adjust the temperature 1 degree. The temperature can be set between 43°F and 57°F (6°C and 14°C).
NOTE: After the wine cellar has been turned off, wait 3 to 5 minutes before restarting.
6
