Sizing the Unit to the Room
Model | Cellar Volume | AMP’s | AMP’s | Product Dimensions |
|
|
|
|
|
| (cubic feet) | (starting) | (running) | (W x H x D) |
|
|
|
|
|
4000 | 1000 | 32 | 9 | 14.25” x 15.75” x 25.5” |
|
|
|
|
|
8000 | 2000 | 36 | 10 | 14.25” x 22” x 27” |
8000ti | 2000 high | 36 | 10 | 14.25” x 22” x 27” |
8000ti | 1750 med | 36 | 10 | 14.25” x 22” x 27” |
|
|
|
|
|
8000ti | 1500 low | 36 | 10 | 14.25” x 22” x 27” |
Cutting the Hole for the WhisperKOOL Unit
Tools Needed
Level
Hammer | Screwdriver | Saw |
Locate the center of the wall upon which the unit will be installed. Using a stud finder, locate the studs on either side of the center point, and mark them with vertical lines.
Mark the horizontal lines with a level
Using a saw, cut along the uppermost horizontal line until your saw reaches the stud. Turn the saw around, inserting it into the cut you have just made, and cut toward the opposite stud so that you have a clean hori- zontal cut between the two studs. Be careful not to cut into the studs themselves.
Now make the second horizontal cut from stud to stud on the line 16” below the first cut.
Using a level and a pencil, mark a horizontal line on the wall between the two studs, approximately 1.25” (or as close as possible if more than 1.25”) from the ceiling.
Using a ruler or measuring tape, measure 16” down, and mark another horizontal line parallel to the first one.
Page 11
