WhisperKool PT-EXPL, 8000 Back of unit, Placement of Unit, Location of Supply and Return Grilles

Placement of Unit

Slide the unit from either the inside or outside wall into your wine cellar with the outer flange flush to the wall. You will need to reverse the mounting flange depending on inside or outside use. Secure the flange to the wall through the pre-drilled holes. The screws should penetrate the studs as well as the upper and lower supports to provide adequate support for the WhisperKOOL system (see illustration). Seal all cracks and gaps around the WhisperKOOL Extreme unit with an air-tight sealant or caulking to prevent air leakage.

Note: If you use decorative molding, it should be attached to the walls and never to the cooling unit itself.

2x4 Upper Support

Wall Stud

Mounting Flange

Back of unit

2x4 Lower Support

Drain Port

Electrical Outlet

Location of Supply and Return Grilles

Locate the supply and return grilles inside the cellar to create an airflow pattern that maximizes air circulation in the room. Avoid short circulation of the air.

Do not:

•Install through-the-wall return air grilles at floor level, as they will collect dust from the floor.

•Mount the unit lower than 18” from the top of the room.

•Locate the supply or return air grille where it is blocked by bottles, boxes or cases.

Page 15