5
Maintaining
Your Lawn
Mower
Deck Care
Clean underside of the mower deck after each use to prevent
1. Disconnect spark plug wire. Drain gasoline from lawn mower or place a piece of plastic under the gas cap.
2. Tip mower so that it rests on the housing. Keep the side with the air cleaner facing up. Hold mower firmly.
WARNING: Never tip the mower more than 90º in any direction and do not leave the mower
tipped for any length of time. Oil can drain into the upper part of the engine causing a starting problem.
3. Scrape and clean the underside of the deck with a suitable tool. Do not spray with water.
4. Put the mower back on its wheels on the ground. If you had put plastic under the gas cap earlier, make
Figure | sure to remove it now. |
|
WARNING
Always stop engine, disconnect spark plug, and ground against engine before performing any type of maintenance on your machine.
General Recommendations
•Always observe safety rules when performing any maintenance.
•The warranty on this lawn mower does not cover items that have been subjected to operator abuse or negligence. To receive full value from warranty, operator must maintain the lawn mower as instructed here.
•Changing of
•All adjustments should be checked at least once each season.
•Periodically check all fasteners and make sure these are tight.
WARNING: Always stop engine, disconnect spark plug, and ground against engine
before performing any type of maintenance on your machine.
Engine Care
NOTE: Refer to the engine operation and mainte- nance sections in this manual for instructions.
•Maintain oil level.
•Service air cleaner every 25 hours under normal conditions. Clean every few hours under extremely dusty conditions.
•Clean spark plug and reset the gap once a season.
•Clean engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to permit proper air circulation. Remove all grass, dirt, and combustible debris from muffler area.
Replacing Rear Flap
1.To remove rear flap, cut off the flat end of the wire rod which secures it to the deck, Figure
2.Attach the new flap and new rod to deck, bending the ends of the new rod over to secure to deck.
Do not use a pressure washer or garden hose to clean your unit. These may cause damage to electric components, spindles, pulleys, bearings, or the engine. The use of water will result in shortened life and reduce serviceability.
Lubrication
1.Lubricate pivot points on the blade control at least once a season with light oil. The blade control must
operate freely in both directions, Figure
2. Lubricate the wheels at least once a season with light oil (or motor oil). If wheels are removed for any reason, lubricate surface of the pivot arm and inner surface of the wheel with light oil, Figure
3. Lubricate the torsion spring and pivot point on the rear discharge door and side mulch plug periodically with light oil to prevent rust, Figure
Figure
10
